European Journal of Biophysics

| Peer-Reviewed |

Tensile Strength of Single Collagen Fibrils Isolated from Tendons

Received: 28 November 2016    Accepted: 07 January 2017    Published: 16 February 2017
Views:       Downloads:

Share This Article

Abstract

Tensile failure properties of single collagen fibrils were determined using our original tensile test method. Fibrils were directly isolated from the fascicles of mouse tail tendons. Both the ends of each fibril were wound onto the tips of two microneedles several times using micromanipulators. The fibril and tips were immersed in physiological saline solution. Then, the fibril was stretched to failure by moving the one microneedle. During tensile testing, the fibril was firmly attached to the tips of the microneedles, and broken between the tips with no slippage observed. The diameter of tested 10 fibrils was 410±60 nm (Mean±S.D.). The stress-strain curves of these fibrils were almost linear. Their tensile strength and failure strain were 100±32 MPa and 34±11%, respectively. These values were approximately 480 and 190% of those of the fascicles with the diameter of 81±12 m, respectively.

DOI 10.11648/j.ejb.20170501.11
Published in European Journal of Biophysics (Volume 5, Issue 1, February 2017)
Page(s) 1-6
Creative Commons

This is an Open Access article, distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution and reproduction in any medium or format, provided the original work is properly cited.

Copyright

Copyright © The Author(s), 2024. Published by Science Publishing Group

Keywords

Collagen, Fibril, Tendon, Mechanical Properties, Tensile Strength

References
[1] J. Kastelic, A. Galeski, and E. Baer, “The multicomposite structure of tendon”, Connect. Tissue Res., vol. 6, pp. 11–23, 1978.
[2] V. Ottani, D. Martini, M. Franchi, A. Ruggeri, and M. Raspanti, “Hierarchical structures in fibrillar collagens”, Micron, vol. 33, pp. 587–596, 2002.
[3] F. H. Silver, J. W. Freeman, and G. P. Seehra, “Collagen self-assembly and the development of tendon mechanical properties”, J. Biomech., vol. 36, pp. 1529–1553, 2003.
[4] N. Yamamoto, K. Hayashi, H. Kuriyama, K. Ohno, K. Yasuda, and K. Kaneda, “Mechanical properties of the rabbit patellar tendon”, J. Biomech. Eng., vol. 114, pp. 332–337, 1992.
[5] E. Yamamoto, K. Hayashi, and N. Yamamoto, “Mechanical properties of collagen fascicles from the rabbit patellar tendon”, J. Biomech. Eng., vol. 121, pp. 124–131, 1999.
[6] H. Miyazaki and K. Hayashi, “Tensile tests of collagen fibers obtained from the rabbit patellar tendon”, Biomed. Microdevices, vol. 2, pp. 151–157, 1999.
[7] R. B. Svensson, T. Hassenkam, C. A. Grant, and S. P. Magnusson, “Tensile properties of human collagen fibrils and fascicles are insensitive to environmental salts”, Biophys. J., vol. 99, pp. 4020–4027, 2010.
[8] R. B. Svensson, H. Mulder, V. Kovanen, and S. P. Magnusson, “Fracture mechanics of collagen fibrils: influence of natural cross-links”, Biophys. J., vol. 104, pp. 2476–2484, 2013.
[9] J. A. van der Rijt, K. O. van der Werf, M. L. Bennink, P. J. Dijkstra, and J. Feijen, “Micromechanical testing of individual collagen fibrils”, Macromol. Biosci., vol. 6, pp. 697–702, 2006.
[10] L. Yang, K. O. van der Werf, P. J. Dijkstram, J. Feijen, and M. L. Bennink, “Micromechanical analysis of native and cross-linked collagen type I fibrils supports the existence of microfibrils”, J. Mech. Behav. Biomed. Mater., vol. 6, pp. 148–158, 2012.
[11] C. A. Grant, D. J. Brockwell, S. E. Radford, and N. H. Thomson, “Effects of hydration on the mechanical response of individual collagen fibrils”, Appl. Phys. Lett., vol. 92, pp. 233902–1–3, 2008.
[12] C. A. Grant, D. J. Brockwell, S. E. Radford, and N. H. Thomson, “Tuning the elastic modulus of hydrated collagen fibrils”, Biophys. J., vol. 97, pp. 2985–2992, 2009.
[13] A. J. Heim, W. G. Matthews, and T. J. Koob, “Determination of the elastic modulus of native collagen fibrils via radial indentation”, Appl. Phys. Lett., vol. 89, pp. 181902–1–3, 2006.
[14] S. Strasser, A. Zink, M. Janko, W. M. Heckl, and S. Thalhammer, “Structural investigations on native collagen type I fibrils using AFM”, Biochem. Biophys. Res. Commun., vol. 354, pp. 27–32, 2007.
[15] M. P. Wenger, L. Bozec, M. A. Horton, and P. Mesquida, “Mechanical properties of collagen fibrils”, Biophys. J., vol. 93, pp. 1255–1263, 2007.
[16] O. G. Andriotis, W. Manuyakorn, J. Zekonyte, O. L. Katsamenis, S. Fabri, P. H. Howarth, D. E. Davies, P. J. Thurner, “Nanomechanical assessment of human and murine collagen fibrils via atomic force microscopy cantilever-based nanoindentation”, J. Mech. Behav. Biomed. Mater., vol. 39, pp. 9–26, 2014.
[17] S. J. Baldwin, A. S. Quigley, C. Clegg, L. Kreplak, “Nanomechanical mapping of hydrated rat tail tendon collagen I fibrils”, Biophys. J., vol. 107, pp. 1794–1801, 2014.
[18] S. J. Baldwin, L. Kreplak, J. M. Lee, “Characterization via atomic force microscopy of discrete plasticity in collagen fibrils from mechanically overloaded tendons: nano-scale structural changes mimic rope failure”, J. Mech. Behav. Biomed. Mater., vol. 60, pp. 356–366, 2016.
[19] E. C. Spitzner, S. Roper, M. Zerson, A. Bernstein, R. Magerle, “Nanoscale swelling heterogeneities in type I collagen fibrils”, ACS NANO, vol. 9, pp. 5683–5694, 2015.
[20] A. J. Heim, T. J. Koob, and W. G. Matthews, “Low strain nanomechanics of collagen fibrils”, Biomacromolecules, vol. 8, pp. 3298–3301, 2007.
[21] L. Yang, K. O. van der Werf, B. F. Koopman, V. Subramaniam, M. L. Bennink, P. J. Dijkstra, and J. Feijen, “Micromechanical bending of single collagen fibrils using atomic force microscopy”, J. Biomed. Mater. Res. A., vol. 82A, pp. 160–168, 2007.
[22] L. Yang, K. O. van der Werf, C. F. Fitie, M. L. Bennink, P. J. Dijkstra, and J. Feijen, “Mechanical properties of native and cross-linked type I collagen fibrils”, Biophys. J., vol. 94, pp. 2204–2211, 2008.
[23] S. J. Eppell, B. N. Smith, H. Kahn, and R. Ballarini, “Nano measurements with micro-devices: mechanical properties of hydrated collagen fibrils”, J. R. Soc. Interface, vol. 3, pp. 117–121, 2006.
[24] Z. L. Shen, M. R. Dodge, H. Kahn, R. Ballarini, and S. J. Eppell, “Stress-strain experiments on individual collagen fibrils”, Biophys. J., vol. 95, pp. 3956–3963, 2008.
[25] Z. L. Shen, M. R. Dodge, H. Kahn, R. Ballarini, and S. J. Eppell, “In vitro fracture testing of submicron diameter collagen fibril specimens”, Biophys. J., vol. 99, pp. 1986–1995, 2010.
[26] J. A. Trotter, F. A. Thurmond, and T. J. Koob, “Molecular structure and functional morphology of echinoderm collagen fibrils”, Cell Tissue Res., vol. 275, pp. 451–458, 1994.
[27] N. Yamamoto and K. Sugiura, “Effects of ground substance on the mechanical properties of fascicles obtained from mouse tail tendons”, Proc. 2nd Japan-Switzerland Workshop on Biomechanics, p. 4, 2005.
Author Information
  • Biomechanics Laboratory, Department of Mechanical Engineering, Ritsumeikan University, Shiga, Japan

Cite This Article
  • APA Style

    Noritaka Yamamoto. (2017). Tensile Strength of Single Collagen Fibrils Isolated from Tendons. European Journal of Biophysics, 5(1), 1-6. https://doi.org/10.11648/j.ejb.20170501.11

    Copy | Download

    ACS Style

    Noritaka Yamamoto. Tensile Strength of Single Collagen Fibrils Isolated from Tendons. Eur. J. Biophys. 2017, 5(1), 1-6. doi: 10.11648/j.ejb.20170501.11

    Copy | Download

    AMA Style

    Noritaka Yamamoto. Tensile Strength of Single Collagen Fibrils Isolated from Tendons. Eur J Biophys. 2017;5(1):1-6. doi: 10.11648/j.ejb.20170501.11

    Copy | Download

  • @article{10.11648/j.ejb.20170501.11,
      author = {Noritaka Yamamoto},
      title = {Tensile Strength of Single Collagen Fibrils Isolated from Tendons},
      journal = {European Journal of Biophysics},
      volume = {5},
      number = {1},
      pages = {1-6},
      doi = {10.11648/j.ejb.20170501.11},
      url = {https://doi.org/10.11648/j.ejb.20170501.11},
      eprint = {https://download.sciencepg.com/pdf/10.11648.j.ejb.20170501.11},
      abstract = {Tensile failure properties of single collagen fibrils were determined using our original tensile test method. Fibrils were directly isolated from the fascicles of mouse tail tendons. Both the ends of each fibril were wound onto the tips of two microneedles several times using micromanipulators. The fibril and tips were immersed in physiological saline solution. Then, the fibril was stretched to failure by moving the one microneedle. During tensile testing, the fibril was firmly attached to the tips of the microneedles, and broken between the tips with no slippage observed. The diameter of tested 10 fibrils was 410±60 nm (Mean±S.D.). The stress-strain curves of these fibrils were almost linear. Their tensile strength and failure strain were 100±32 MPa and 34±11%, respectively. These values were approximately 480 and 190% of those of the fascicles with the diameter of 81±12 m, respectively.},
     year = {2017}
    }
    

    Copy | Download

  • TY  - JOUR
    T1  - Tensile Strength of Single Collagen Fibrils Isolated from Tendons
    AU  - Noritaka Yamamoto
    Y1  - 2017/02/16
    PY  - 2017
    N1  - https://doi.org/10.11648/j.ejb.20170501.11
    DO  - 10.11648/j.ejb.20170501.11
    T2  - European Journal of Biophysics
    JF  - European Journal of Biophysics
    JO  - European Journal of Biophysics
    SP  - 1
    EP  - 6
    PB  - Science Publishing Group
    SN  - 2329-1737
    UR  - https://doi.org/10.11648/j.ejb.20170501.11
    AB  - Tensile failure properties of single collagen fibrils were determined using our original tensile test method. Fibrils were directly isolated from the fascicles of mouse tail tendons. Both the ends of each fibril were wound onto the tips of two microneedles several times using micromanipulators. The fibril and tips were immersed in physiological saline solution. Then, the fibril was stretched to failure by moving the one microneedle. During tensile testing, the fibril was firmly attached to the tips of the microneedles, and broken between the tips with no slippage observed. The diameter of tested 10 fibrils was 410±60 nm (Mean±S.D.). The stress-strain curves of these fibrils were almost linear. Their tensile strength and failure strain were 100±32 MPa and 34±11%, respectively. These values were approximately 480 and 190% of those of the fascicles with the diameter of 81±12 m, respectively.
    VL  - 5
    IS  - 1
    ER  - 

    Copy | Download

  • Sections