Dye-Sensitized Solar Cell Using Copper and Nitrogen Co-doped Titania as Photoanode
International Journal of Sustainable and Green Energy
Volume 4, Issue 6, November 2015, Pages: 219-226
Received: Oct. 22, 2015;
Accepted: Nov. 2, 2015;
Published: Nov. 24, 2015
Views 4849 Downloads 172
Purnima Dashora, Department of Chemistry, PAHER University, Udaipur, (Raj.) India
Chetna Ameta, Department of Chemistry, PAHER University, Udaipur, (Raj.) India
Rakshit Ameta, Department of Chemistry, PAHER University, Udaipur, (Raj.) India
Suresh C. Ameta, Department of Chemistry, PAHER University, Udaipur, (Raj.) India
Energy crisis is a burning problem in the present scenario, as natural energy resources will be exhausted very soon, due to their rapid utilization. Solar cells have attracted the attention of researchers, as using these devices sunlight can be converted into electricity, which is freely available to us. DSSCs is one of the important and new type of solar cell, which deliver higher photoelectric conversion efficiency and low production cost by combining wide-band gap semiconductor electrode, dye as sensitizer, a counter electrode and redox electrolyte like iodide and triiodide ions between them. In the present work, a comparison is made for the efficiency of pure TiO2 and Cu/N co-doped TiO2 fabricated DSSCs. Pure TiO2 and Cu/N co-doped TiO2 were prepared through sol-gel process. These electrodes were also characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), fourier transform infrared (FTIR), transmission electron microscopy (TEM) and diffuse reflectance spectra (DRS) techniques to know about their morphology, band gap, particle size etc. The cell was prepared by coating of Cu/N‒TiO2 film on the conductive side of FTO glasses using Rhodamine B dye as sensitizer. Liquid electrolyte I‒/I3‒ redox couple and carbon (graphite) as counter electrode and light intensity 60 mWcm‒2 were used. The observations revealed that Cu/N doped electrode showed maximum conversion efficiency with an open circuit voltage (Voc) = 395.0 mV, short circuit current (isc) = 0.0339 mA, Vpp = 66.2 mV and ipp = 0.0209 mA with fill factor = 0.10 and the power conversion efficiency (η) = 0.0023%, which is higher than that of pure TiO2. The results showed that the doping of TiO2 by copper and nitrogen improved the efficiency of this solar cell 38 times more in compare to pure TiO2.
Suresh C. Ameta,
Dye-Sensitized Solar Cell Using Copper and Nitrogen Co-doped Titania as Photoanode, International Journal of Sustainable and Green Energy.
Vol. 4, No. 6,
2015, pp. 219-226.
O'Regan, B., Grätzel, M. A low-cost, high-efficiency solar cell based on dye-sensitized colloidal TiO2 films, Nature, Vol. 353, pp. 737-740, 1991.
Chiba, Y., Islam, A., Watanabe, Y., Komiya, R., Koide, N., Han, L., Dye-sensitized solar cells with conversion efficiency of 11.1%. Japn. J. Appl. Phys. Part 2: Letters, Vol. 45, pp. L638-L640, 2006.
Elangovan, R., Venkatachalam, P. Co-sensitization Promoted Light Harvesting for Dye-Sensitized Solar Cells, J. Inorg. Organomet. Polymer Mater., Vol. 25, pp. 823-831, 2015.
Pang, A. Sun, X. Ruan, H. Li, Y. Dai, S. Wei, M. Highly efficient dye-sensitized solar cells composed of TiO2@SnO2 core-shell microspheres, Nano Energy, Vol. 5, pp. 82-90, 2014.
Eom, T.S., Kim, K.H., Bark, C.W., Choi, H.W., Influence of Fe2O3 doping on TiO2 electrode for enhancement photovoltaic efficiency of dye-sensitized solar cells, Mol. Cryst. Liq. Cryst., Vol. 600, pp. 39-46, 2014.
J. Y. Park, K.H. Lee , B. S. Kim, C. S. Kim , S. E. Lee, K. Okuyama, H. D. Jang, and T. O. Kim, Enhancement of dye-sensitized solar cells using Zr/N-doped TiO2 composites as photoelectrodes, RSC Adv., vol. 4, pp. 9946-9952, 2014.
F. Gu, W. Huang , S. Wang, X. Cheng ,Y.Hu, and P. S. Lee, Open-circuit voltage improvement in tantalum-doped TiO2 nanocrystals, Phys. Chem. Chem. Phys., vol. 16, no. 47, pp. 25679-2568, 2014.
Yanan Xie, Niu Huang, Sujian You, Yumin Liu, Bobby Sebo, Liangliang Liang, Xiaoli Fang, Wei Liu, Shishang Guo, Xing-Zhong Zhao, Improved performance of dye-sensitized solar cells by trace amount Cr-doped TiO2 photoelectrodes, J. Power Sources, vol. 224, pp. 168-173, 2013.
Chuen-Shii Chou, Yan-Hao Huang, Ping Wuc, Yi-Ting Kuo, Chemical-photo-electricity diagrams by Ohm’s law – A case study of Ni-doped TiO2 solutions in dye-sensitized solar cells, Appl. Energy, vol. 118, pp. 12–21, 2014.
Niu, M. Cui, R. Wu, H. Cheng, D. Cao, D. Enhancement mechanism of the conversion efficiency of dye-sensitized solar cells based on nitrogen, fluorine, and iodine doped TiO2 photoanodes, J. Phys. Chem. C, Vol. 119, pp. 13425-13432, 2015.
C-H. Han, H-S. Lee,K-W. Lee, S-D. Han, and I. Singh, Synthesis of Amorphous Er3+-Yb3+ Co-doped TiO2 and Its Application as a Scattering Layer for Dye-sensitized Solar Cells, Bull. Korean Chem. Soc., Vol. 30, pp. 219-223, 2009.
Duan, Y., Zheng, J., Xu, M., Song, X., Fu, N., Fang, Y., Zhou, X., Lin, Y., Pan, F., Metal and F dual-doping to synchronously improve electron transport rate and lifetime for TiO2 photoanode to enhance dye-sensitized solar cells performances, J. Mater. Chem. A, vol. 3, pp. 5692-5700, 2015.
R. Ocwelwang and L. Tichagwa, Synthesis and Characterization of Ag and Nitrogen Doped TiO2 Nanoparticles Supported on A Chitosan-PVAE Nanofibre Support, Int. J. Adv. Res. Chem. Sci., vol. 1, pp. 28-37, 2014.
R. Sharmila Devi, Dr. R. Venckatesh, and Dr. Rajeshwari Sivaraj, Synthesis of Titanium Dioxide Nanoparticles by Sol-Gel Technique, Int. J. Innov. Res. Sci. Eng. Technol., vol. 3, pp. 15206-15211, (2014).
B. V. Rao, A. D. P. Rao and V. Raghavendra Reddy, Influence of Mo6+ On Ftir And Mössbauer Spectroscopic Properties of Copper Ferrite, Int. J. Innov. Res. Sci. Eng. Technol, vol. 2, pp. 7768-7779, 2013.
H. Tachikawa, T. Iyama and T. Hamabayashi, Metal–ligand interactions of the Cu–NO complex at the ground and low-lying excited states: an ab initioMO study, Electron. J. Theor. CH., vol. 2, pp. 263–267, 1997.
A. Rahmati, Nitrification of Reactively Magnetron Sputter Deposited Ti-Cu Nano-Composite Thin Films, Soft Nanoscience Letters, vol. 3, pp. 14-21, 2013.
H. Diker, C. Varlikli, K. Mizrak, and A. Dana, Characterizations and photocatalytic activity comparisons of N-doped nc-TiO2 depending on synthetic conditions and structural differences of amine sources, Energy, vol. 36, pp. 1243-1254, 2011.
K. Lv, H. Zuo, J. Sun, K. Deng, S. Liu, X. Li, and D. Wang, (Bi, C and N) codoped TiO2 nanoparticles, J. Hazard. Mater., vol. 161, pp. 396–401, 2009.