Archive
Special Issues
Design and Fabrication of a Dc Driver Circuit Control Dc Motor
International Journal of Energy and Power Engineering
Volume 2, Issue 1, February 2013, Pages: 1-11
Received: Jan. 3, 2013; Published: Feb. 20, 2013
Views 3601      Downloads 595
Authors
Diponkar Paul, Dept of EEE World University of Bangladesh
Rajib Mondal, Dept of EEE World University of Bangladesh
Article Tools
PDF
Follow on us
Abstract
A DC Motor Driver is a device that drives motor, typically as a speed controller of motor. This DC Motor Driver circuit uses a 741 operational amplifier operating as a voltage follower where its non inverting input is connected to the speed and rotation direction of a potentiometer. When the potentiometer is turned towards the positive supply side, the output will go positive voltage and NPN transistor will supply the current to the motor and PNP transistor will be OFF. When the potentiometer is turned to the negative supply side, the op-amp output switches to the negative voltage and NPN Transistor will turn OFF and PNP Transistor ON which reverses the rotation of the motor's direction. It has been design along with Op-Amp to drive the motor. The fabrication results of DC Motor Driver provide very good results. The total cost of fabricated our dc motor driver using Op-Amp is comparatively cheaper than the traditional dc Motor Driver available in market price. A DC Motor specification is taken and corresponding parameters are found out from derived design approach. Ultimately simulation is done for model with and without filter used after reference speed and a comparative study has been done on response of both cases. Further it is purposed that in industrial environment these controllers are better than others controllers as Op-Amp controllers are easy and cheap.
Keywords
Dc Driver Circuit, TB+, Half Cycle
To cite this article
Diponkar Paul, Rajib Mondal, Design and Fabrication of a Dc Driver Circuit Control Dc Motor, International Journal of Energy and Power Engineering. Vol. 2, No. 1, 2013, pp. 1-11. doi: 10.11648/j.ijepe.20130201.11
References
[1]
B.L Theraja & A.K Theraja, AC & DC Machines, Khanna Publishers, New Delhi, 2003.
[2]
Bimbhra, P.S., Power Electronics, Khanna Publishers, New Delhi, 2006.
[3]
Dubey, G.K., Fundamentals of Electrical Drives. New Delhi, Narosa Publishing House, 2000.
[4]
Rashid, M.H., Power Electronics, Prentice Hall of India, New Delhi, 1993.
[5]
Infineon Technologies, Basic DC motor speed PID control with the Infineon Technologies, 1996.
[6]
Salam Dr. Zainal, UTJMB, Power Electronics and Drives (Version 3-2003).
[7]
Gopal, M., Control Systems, Principles and Design. New Delhi, Tata McGraw Hill Publishing Company limited 2008.
[8]
J.D Nicould, O Matthey and G.Caprari, "Control and Analysis of Low Inertia Miniature Synchronous Motors". International Symposium on Micromehantronics and Human Science, 1998.
[9]
Advanced PM brushless DC motor control and system for electric vehicle, Fang Lin Luo; Hock Guan Yeo, 1990.
[10]
Delmar, Herman, Stephen L. Cengage Learning, Electric Motor Control, 9th ed. 2009.
[11]
http://www.electronics-project-design.com.
ADDRESS
Science Publishing Group
1 Rockefeller Plaza,
10th and 11th Floors,
New York, NY 10020
U.S.A.
Tel: (001)347-983-5186