Smart Generator Monitoring System in Industry Using Microcontroller

S. Boopathi; M. Jagadeeshraja; L. Manivannan; M. Dhanasu

doi:doi:10.11648/j.epes.20150404.13

| Peer-Reviewed

Smart Generator Monitoring System in Industry Using Microcontroller

S. Boopathi, M. Jagadeeshraja, L. Manivannan, M. Dhanasu

Published in American Journal of Electrical Power and Energy Systems (Volume 4, Issue 4)

Received: 7 May 2015 Accepted: 20 May 2015 Published: 6 June 2015

Views: Downloads:

Download PDF

Share This Article

Twitter
Linked In
Facebook

Abstract

The electrical power systems are highly non-linear, extremely huge and complex networks. On the other hand, all the developed and countries have not sufficient supply of power. My Project focuses the detection of power failure and takes reflex action to solve the problem with help of GSM communication. The power failure will be detect by relay, and it communicates to Microcontroller to alerts the authorized person. In addition to that, parameters of Generator like Fuel level, Oil level, Temperature, battery status, etc., are monitored and communicated to authorized person. The acquired parameters are processed and recorded in the system memory. If there is any abnormality in their process, according to some predefined instruction and policies that are stored on the embedded system EEPROM then GSM alerts to concerned person immediately.

Published in	American Journal of Electrical Power and Energy Systems (Volume 4, Issue 4)
DOI	10.11648/j.epes.20150404.13
Page(s)	45-50
Creative Commons	This is an Open Access article, distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution and reproduction in any medium or format, provided the original work is properly cited.
Copyright	Copyright © The Author(s), 2024. Published by Science Publishing Group

Keywords

Microcontroller, GSM Modem (SIM 300), Fuel Level (PH606), Oil Level (R Series), Temperature Sensors (LM35)

References

[1]	Amit Sachan, “Microcontroller based Based Substation Monitoring and Control System with Gsm Modem” IOSR Journal of Electrical and Electronics Engineering, ISSN: 2278-1676 Volume 1, Issue 6 (July-Aug. 2012).
[2]	Mallikarjun Sarsamba “The Load Monitoring and Protection on Electricity Power lines using GSM Network” International Journal of Advanced Research in Computer Science and Software Engineering, Volume 3, Issue 9, September 2013 ISSN: 2277 128X.
[3]	S.Vimalraj, Gausalya.R.B, “GSM Based Controlled Switching Circuit between Supply Mains and Captive Power Plant” International Journal of Computational Engineering Research, Vol, 03, Issue, 4.April 2013.
[4]	Andriy Palamar “Control System for a Diesel Generator and UPS Based Microgrid”, Scientific Journal of Riga Technical University Power and Electrical Engineering, Volume 27, 2010.
[5]	Kwang Seon Ahn “Digital Controller of a Diesel Generator using an Embedded System” International Journal of Information Processing Systems, Vol.2, No.3, December 2006.
[6]	Henrik arleving “ways to cut power generator maintanence”the journal, December 2013.
[7]	Chetan Patil, Channabasappa Baligar, “Base Transceiver Station (BTS) Safety and Fault Management”, International Journal of Innovative Technology and Exploring Engineering (IJITEE) ISSN: 2278-3075, Volume-3, Issue-7, December 2013.
[8]	Y Jaganmohan Reddy, Y V Pavan Kumar, K Padma Raju, Anilkumar Ramsesh, “PLC Based Energy Management and Control Design for an Alternative Energy Power System with Improved Power Quality”, International Journal of Engineering Research and Applications (IJERA) ISSN: 2248-9622 Vol. 3, Issue 3, May-Jun 2013.
[9]	Alper T. Alan “A Field Study of Human-Agent Interaction for Electricity Tariff Switching”, Agents, Interaction and Complexity Group, University of Southampton, Southampton, UK.
[10]	J. Pierce and E. Paulos. Beyond energy monitors: interaction, energy, and emerging energy systems. In Proc. CHI’12. ACM, 2012.

Cite This Article

Plain Text BibTeX RIS

APA Style

S. Boopathi, M. Jagadeeshraja, L. Manivannan, M. Dhanasu. (2015). Smart Generator Monitoring System in Industry Using Microcontroller. American Journal of Electrical Power and Energy Systems, 4(4), 45-50. https://doi.org/10.11648/j.epes.20150404.13

Copy | Download

ACS Style

S. Boopathi; M. Jagadeeshraja; L. Manivannan; M. Dhanasu. Smart Generator Monitoring System in Industry Using Microcontroller. Am. J. Electr. Power Energy Syst. 2015, 4(4), 45-50. doi: 10.11648/j.epes.20150404.13

Copy | Download

AMA Style

S. Boopathi, M. Jagadeeshraja, L. Manivannan, M. Dhanasu. Smart Generator Monitoring System in Industry Using Microcontroller. Am J Electr Power Energy Syst. 2015;4(4):45-50. doi: 10.11648/j.epes.20150404.13

Copy | Download

@article{10.11648/j.epes.20150404.13,
  author = {S. Boopathi and M. Jagadeeshraja and L. Manivannan and M. Dhanasu},
  title = {Smart Generator Monitoring System in Industry Using Microcontroller},
  journal = {American Journal of Electrical Power and Energy Systems},
  volume = {4},
  number = {4},
  pages = {45-50},
  doi = {10.11648/j.epes.20150404.13},
  url = {https://doi.org/10.11648/j.epes.20150404.13},
  eprint = {https://article.sciencepublishinggroup.com/pdf/10.11648.j.epes.20150404.13},
  abstract = {The electrical power systems are highly non-linear, extremely huge and complex networks. On the other hand, all the developed and countries have not sufficient supply of power. My Project focuses the detection of power failure and takes reflex action to solve the problem with help of GSM communication. The power failure will be detect by relay, and it communicates to Microcontroller to alerts the authorized person. In addition to that, parameters of Generator like Fuel level, Oil level, Temperature, battery status, etc., are monitored and communicated to authorized person. The acquired parameters are processed and recorded in the system memory. If there is any abnormality in their process, according to some predefined instruction and policies that are stored on the embedded system EEPROM then GSM alerts to concerned person immediately.},
 year = {2015}
}

Copy | Download

TY  - JOUR
T1  - Smart Generator Monitoring System in Industry Using Microcontroller
AU  - S. Boopathi
AU  - M. Jagadeeshraja
AU  - L. Manivannan
AU  - M. Dhanasu
Y1  - 2015/06/06
PY  - 2015
N1  - https://doi.org/10.11648/j.epes.20150404.13
DO  - 10.11648/j.epes.20150404.13
T2  - American Journal of Electrical Power and Energy Systems
JF  - American Journal of Electrical Power and Energy Systems
JO  - American Journal of Electrical Power and Energy Systems
SP  - 45
EP  - 50
PB  - Science Publishing Group
SN  - 2326-9200
UR  - https://doi.org/10.11648/j.epes.20150404.13
AB  - The electrical power systems are highly non-linear, extremely huge and complex networks. On the other hand, all the developed and countries have not sufficient supply of power. My Project focuses the detection of power failure and takes reflex action to solve the problem with help of GSM communication. The power failure will be detect by relay, and it communicates to Microcontroller to alerts the authorized person. In addition to that, parameters of Generator like Fuel level, Oil level, Temperature, battery status, etc., are monitored and communicated to authorized person. The acquired parameters are processed and recorded in the system memory. If there is any abnormality in their process, according to some predefined instruction and policies that are stored on the embedded system EEPROM then GSM alerts to concerned person immediately.
VL  - 4
IS  - 4
ER  -

Copy | Download

Author Information

S. Boopathi

Embedded System Technologies, Knowledge Institute of Technology, Tamilnadu, India
M. Jagadeeshraja

Department of Electrical and Electronics Engineering, Knowledge Institute of Technology, Tamilnadu, India
L. Manivannan

Department of Electrical and Electronics Engineering, Knowledge Institute of Technology, Tamilnadu, India
M. Dhanasu

Steel Authority of India, Tamilnadu, India

Download PDF

Sections

Plain Text BibTeX RIS

APA Style

S. Boopathi, M. Jagadeeshraja, L. Manivannan, M. Dhanasu. (2015). Smart Generator Monitoring System in Industry Using Microcontroller. American Journal of Electrical Power and Energy Systems, 4(4), 45-50. https://doi.org/10.11648/j.epes.20150404.13

Copy | Download

ACS Style

S. Boopathi; M. Jagadeeshraja; L. Manivannan; M. Dhanasu. Smart Generator Monitoring System in Industry Using Microcontroller. Am. J. Electr. Power Energy Syst. 2015, 4(4), 45-50. doi: 10.11648/j.epes.20150404.13

Copy | Download

AMA Style

S. Boopathi, M. Jagadeeshraja, L. Manivannan, M. Dhanasu. Smart Generator Monitoring System in Industry Using Microcontroller. Am J Electr Power Energy Syst. 2015;4(4):45-50. doi: 10.11648/j.epes.20150404.13

Copy | Download

@article{10.11648/j.epes.20150404.13,
  author = {S. Boopathi and M. Jagadeeshraja and L. Manivannan and M. Dhanasu},
  title = {Smart Generator Monitoring System in Industry Using Microcontroller},
  journal = {American Journal of Electrical Power and Energy Systems},
  volume = {4},
  number = {4},
  pages = {45-50},
  doi = {10.11648/j.epes.20150404.13},
  url = {https://doi.org/10.11648/j.epes.20150404.13},
  eprint = {https://article.sciencepublishinggroup.com/pdf/10.11648.j.epes.20150404.13},
  abstract = {The electrical power systems are highly non-linear, extremely huge and complex networks. On the other hand, all the developed and countries have not sufficient supply of power. My Project focuses the detection of power failure and takes reflex action to solve the problem with help of GSM communication. The power failure will be detect by relay, and it communicates to Microcontroller to alerts the authorized person. In addition to that, parameters of Generator like Fuel level, Oil level, Temperature, battery status, etc., are monitored and communicated to authorized person. The acquired parameters are processed and recorded in the system memory. If there is any abnormality in their process, according to some predefined instruction and policies that are stored on the embedded system EEPROM then GSM alerts to concerned person immediately.},
 year = {2015}
}

Copy | Download

TY  - JOUR
T1  - Smart Generator Monitoring System in Industry Using Microcontroller
AU  - S. Boopathi
AU  - M. Jagadeeshraja
AU  - L. Manivannan
AU  - M. Dhanasu
Y1  - 2015/06/06
PY  - 2015
N1  - https://doi.org/10.11648/j.epes.20150404.13
DO  - 10.11648/j.epes.20150404.13
T2  - American Journal of Electrical Power and Energy Systems
JF  - American Journal of Electrical Power and Energy Systems
JO  - American Journal of Electrical Power and Energy Systems
SP  - 45
EP  - 50
PB  - Science Publishing Group
SN  - 2326-9200
UR  - https://doi.org/10.11648/j.epes.20150404.13
AB  - The electrical power systems are highly non-linear, extremely huge and complex networks. On the other hand, all the developed and countries have not sufficient supply of power. My Project focuses the detection of power failure and takes reflex action to solve the problem with help of GSM communication. The power failure will be detect by relay, and it communicates to Microcontroller to alerts the authorized person. In addition to that, parameters of Generator like Fuel level, Oil level, Temperature, battery status, etc., are monitored and communicated to authorized person. The acquired parameters are processed and recorded in the system memory. If there is any abnormality in their process, according to some predefined instruction and policies that are stored on the embedded system EEPROM then GSM alerts to concerned person immediately.
VL  - 4
IS  - 4
ER  -

Copy | Download