A new method of current control strategy for grid connected photovoltaic (PV) system is presented in this paper. The connection of photovoltaic system with the grid is a difficult task as the solar irradiation is a nonlinear quantity. The objective of this work is to develop a model of the photovoltaic system with maximum power point tracking (MPPT) system connected to 11 KV grid by implementing new control technique so that maximum active power transfer from PV to grid can be taken place without injection of harmonics. The considered system consists of a PV system, MPPT controller, boost converter, voltage source inverter (VSI), 3-Φ filter, a control system, a distribution network, load and grid. In the beginning, a model of a photovoltaic array was developed and then a MPPT controller and a direct current to direct current (DC-DC) converter are designed. To connect PV system to grid, a power electronics converter is needed which can convert DC voltage into three- phase AC voltage. Three-phase VSI using insulated gate bipolar transistors (IGBTs) is used. By means of a step-up transformer and filter, this three-phase VSI is connected to the distribution network. The proposed control of the three-phase grid-connected solar PV system is designed in the synchronously-rotating d-q reference frame. Here, Vdc is measured, then compared with Vdcref and accordingly the error is fed to proportional-integral (PI) controller from which Idref is generated. As PV system should inject only active power, so reactive power injected to grid is made zero by making Iqref zero. There after the final model is simulated by using MATLAB/SIMULINK and different output waveforms are analyzed for different conditions. Finally the fault analysis is carried out to observe the behavior of the system.
| Published in | American Journal of Electrical Power and Energy Systems (Volume 5, Issue 4) |
| DOI | 10.11648/j.epes.20160504.12 |
| Page(s) | 35-44 |
| Creative Commons |
This is an Open Access article, distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution and reproduction in any medium or format, provided the original work is properly cited. |
| Copyright |
Copyright © The Author(s), 2024. Published by Science Publishing Group |
Grid-connected PV System, MPPT, Voltage Source Inverter (VSI), PWM Technique, LLLG Fault, MATLAB/Simulink
| [1] | G. Farivar, B. Asaei, "A New Approach for Solar Module Temperature Estimation using the Simple Diode Model", IEEE Transactions on Energy Conversion, Vol.26, No.4, Dec. 2011, pp.1118-1126. |
| [2] | M. F. Schonardie, D. C. Martins, "Application of the dq0 Transformation in the Three-Phase Grid-Connected PV Systems with Active and Reactive Power Control", IEEE International Conference on Sustainable Energy Technologies, Singapore, 2008, pp. 18-23. |
| [3] | W. Cai, H. Ren, Y. Jiao, M. Cai, X. Cheng, "Analysis and Simulation for Grid-Connected Photovoltaic System based on MATLAB", International Conference on Electrical and Control Engineering (ICECE), Yichang, 2011, pp.63-66. |
| [4] | A. Yazdani, P. P. Dash, "A Control Methodology and Characterization of Dynamics for a Photovoltaic (PV) System Interfaced with a Distribution Network" IEEE Transactions on Power Delivery, Vol.24, No.3, July 2009, pp.1538-1551. |
| [5] | F. Blaabjerg, R. Teodorescu, M. Liserre, A. V. Timbus, "Overview of Control and Grid Synchronization for Distributed Power Generation Systems", IEEE Transactions on Industrial Electronics, Vol.53, No.5, Oct. 2006, pp.1398-1409. |
| [6] | R. Sunny, R. Anto, "Harmonics Control and Performance Analysis of a Grid-Connected Photovoltaic System", International Conference on Advanced Computing and Communication Systems (ICACCS), Coimbatore, 2013, pp. 1-6. |
| [7] | Z. Dejia, Z. Zhengming, M. Eltawil, Y. Liqiang, "Design and Control of a Three-Phase Grid-Connected Photovoltaic System with Developed Maximum Power Point Tracking", Twenty-Third Annual IEEE Applied Power Electronics Conference and Exposition, Austin, TX, 2008, pp.973-979. |
| [8] | S. Meshram, G. Agnihotri, S. Gupta, "An Efficient Constant Current Controller for PV Solar Power Generator Integrated with the Grid", Fifth IEEE Power India Conference, Murthal, 2012, pp.1-6. |
| [9] | S. B. Kjaer, J. K. Pedersen, F. Blaabjerg, “A Review of Single- Phase Grid-Connected Inverters for Photovoltaic Modules”, IEEE Trans. Ind Appl., Vol.41, No.5, Sep./Oct. 2005, pp.1292–1306. |
| [10] | J. M. Carrasco, L. G. Franquelo, J. T. Bialasiewicz, E. Galvan, R. C. P. Guisado, M. A. M. Prats, J. I. Leon, N. Moreno-Alfonso, “Power Electronic Systems for the Grid Integration of Renewable Energy Sources: A survey”, IEEE Trans.on Ind. Electron, Vol.53, No.4, Aug. 2006, pp.1002–1016. |
| [11] | J. H. R. Enslin, P. J. M. Heskes, “Harmonic Interaction between a Large Number of Distributed Power Inverters and the Distribution Network”, IEEE Trans. on Power Electron, Vol.19, No.6, Nov. 2004, pp.1586–1593. |
| [12] | N. Srisaen, A. Sangswang, “Effect of PV Grid-Connected System Location on a Distribution System”, Proc. Of IEEE Asia Pacific Conf. on Circuit and Systems, Dec. 2006, pp.852–855. |
| [13] | B. K. Naik, M. Das, T. K. Chatterjee, K. Chatterjee, "Study and implementation of synchronization algorithm in three phase grid connected PV system", 3rd International Conference on Recent Advances in Information Technology (RAIT), Dhanbad, 2016, pp.304-309. |
| [14] | Y. Teng, C. Xiong, C. Li, Z. Zhang, X. Yu, W. Zhang, "Study on harmonic and reactive current detection in grid-connected PV Power stations", IEEE International Conference on Progress in Informatics and Computing (PIC), Nanjing, 2015, pp. 433-437. |
| [15] | S. A. Lakshmanan, A. Jain, B.S. Rajpurohit, "Grid voltage monitoring techniques for single phase grid connected solar PV system", IEEE 6th India International Conference on Power Electronics (IICPE), Kurukshetra, 2014, pp.1-6. |
| [16] | P. A. Pattanaik, N. K. Pilli, S. K. Singh, "Design, simulation & performance evaluation of three phase grid connected PV panel," IEEE Power, Communication and Information Technology Conference (PCITC), Bhubaneswar, 2015, pp.195-200. |
APA Style
Prakash Kumar Hota, Babita Panda, Bhagabat Panda. (2016). Fault Analysis of Grid Connected Photovoltaic System. American Journal of Electrical Power and Energy Systems, 5(4), 35-44. https://doi.org/10.11648/j.epes.20160504.12
ACS Style
Prakash Kumar Hota; Babita Panda; Bhagabat Panda. Fault Analysis of Grid Connected Photovoltaic System. Am. J. Electr. Power Energy Syst. 2016, 5(4), 35-44. doi: 10.11648/j.epes.20160504.12
AMA Style
Prakash Kumar Hota, Babita Panda, Bhagabat Panda. Fault Analysis of Grid Connected Photovoltaic System. Am J Electr Power Energy Syst. 2016;5(4):35-44. doi: 10.11648/j.epes.20160504.12
Share This Article
Twitter
Linked In
Facebook
Copy
Download@article{10.11648/j.epes.20160504.12,
author = {Prakash Kumar Hota and Babita Panda and Bhagabat Panda},
title = {Fault Analysis of Grid Connected Photovoltaic System},
journal = {American Journal of Electrical Power and Energy Systems},
volume = {5},
number = {4},
pages = {35-44},
doi = {10.11648/j.epes.20160504.12},
url = {https://doi.org/10.11648/j.epes.20160504.12},
eprint = {https://article.sciencepublishinggroup.com/pdf/10.11648.j.epes.20160504.12},
abstract = {A new method of current control strategy for grid connected photovoltaic (PV) system is presented in this paper. The connection of photovoltaic system with the grid is a difficult task as the solar irradiation is a nonlinear quantity. The objective of this work is to develop a model of the photovoltaic system with maximum power point tracking (MPPT) system connected to 11 KV grid by implementing new control technique so that maximum active power transfer from PV to grid can be taken place without injection of harmonics. The considered system consists of a PV system, MPPT controller, boost converter, voltage source inverter (VSI), 3-Φ filter, a control system, a distribution network, load and grid. In the beginning, a model of a photovoltaic array was developed and then a MPPT controller and a direct current to direct current (DC-DC) converter are designed. To connect PV system to grid, a power electronics converter is needed which can convert DC voltage into three- phase AC voltage. Three-phase VSI using insulated gate bipolar transistors (IGBTs) is used. By means of a step-up transformer and filter, this three-phase VSI is connected to the distribution network. The proposed control of the three-phase grid-connected solar PV system is designed in the synchronously-rotating d-q reference frame. Here, Vdc is measured, then compared with Vdcref and accordingly the error is fed to proportional-integral (PI) controller from which Idref is generated. As PV system should inject only active power, so reactive power injected to grid is made zero by making Iqref zero. There after the final model is simulated by using MATLAB/SIMULINK and different output waveforms are analyzed for different conditions. Finally the fault analysis is carried out to observe the behavior of the system.},
year = {2016}
}
TY - JOUR T1 - Fault Analysis of Grid Connected Photovoltaic System AU - Prakash Kumar Hota AU - Babita Panda AU - Bhagabat Panda Y1 - 2016/09/29 PY - 2016 N1 - https://doi.org/10.11648/j.epes.20160504.12 DO - 10.11648/j.epes.20160504.12 T2 - American Journal of Electrical Power and Energy Systems JF - American Journal of Electrical Power and Energy Systems JO - American Journal of Electrical Power and Energy Systems SP - 35 EP - 44 PB - Science Publishing Group SN - 2326-9200 UR - https://doi.org/10.11648/j.epes.20160504.12 AB - A new method of current control strategy for grid connected photovoltaic (PV) system is presented in this paper. The connection of photovoltaic system with the grid is a difficult task as the solar irradiation is a nonlinear quantity. The objective of this work is to develop a model of the photovoltaic system with maximum power point tracking (MPPT) system connected to 11 KV grid by implementing new control technique so that maximum active power transfer from PV to grid can be taken place without injection of harmonics. The considered system consists of a PV system, MPPT controller, boost converter, voltage source inverter (VSI), 3-Φ filter, a control system, a distribution network, load and grid. In the beginning, a model of a photovoltaic array was developed and then a MPPT controller and a direct current to direct current (DC-DC) converter are designed. To connect PV system to grid, a power electronics converter is needed which can convert DC voltage into three- phase AC voltage. Three-phase VSI using insulated gate bipolar transistors (IGBTs) is used. By means of a step-up transformer and filter, this three-phase VSI is connected to the distribution network. The proposed control of the three-phase grid-connected solar PV system is designed in the synchronously-rotating d-q reference frame. Here, Vdc is measured, then compared with Vdcref and accordingly the error is fed to proportional-integral (PI) controller from which Idref is generated. As PV system should inject only active power, so reactive power injected to grid is made zero by making Iqref zero. There after the final model is simulated by using MATLAB/SIMULINK and different output waveforms are analyzed for different conditions. Finally the fault analysis is carried out to observe the behavior of the system. VL - 5 IS - 4 ER -
Information
Email: