A Review on Numerical and Experimental Results of Hydrogen Addition to Natural Gas in Internal Combustion Engines
International Journal of Sustainable and Green Energy
Volume 3, Issue 1, January 2014, Pages: 6-12
Received: Nov. 16, 2013;
Published: Jan. 10, 2014
Views 3895 Downloads 166
Javad Zareei, Department of Automotive Engineering, Faculty of Mechanical Engineering, Standard Research Institute, Tehran, Iran; Centre for automotive research, Faculty of Engineering & the Built Environment, University Kebangsaan Malaysia
Faizal Wan Mahmood, Centre for automotive research, Faculty of Engineering & the Built Environment, University Kebangsaan Malaysia
Shahrir Abdullah, Centre for automotive research, Faculty of Engineering & the Built Environment, University Kebangsaan Malaysia
Yusoff Ali, Centre for automotive research, Faculty of Engineering & the Built Environment, University Kebangsaan Malaysia
Conventional fossil fuel for combustion system, such as gasoline and petroleum have long been recognized as powerful energy source, however these have a number of problems related to emissions and energy security. The use of hydrogen blends with natural gas is a viable alternative to pure fossil fuels because of the expected reduction of the total pollutant emissions and increase of efficiency. Enhancement of chemical reaction with hydrogen addition is regarded as the increase of H, O and OH free radical mole fraction in the flame. Also in SI engines will move the lean limit to leaner mixture, increasing the combustion speed and temperature. Results show that the hydrogen has a catalyzing effect in the ignition of hydrocarbons with only a few percent addition of hydrogen by volume and by adding it to the pure natural gas (CNG) this difference in spark advance of the engine may be reduced, as a result of the higher flame speed of hydrogen. In this paper, we present the advances and development made on internal combustion engines which operate with mixture of hydrogen/CNG, doing more emphasis in the combustion process, ignition energy and injection systems. Also this paper mentions a comparison that experimental and numerical results match quite well expect for extremely fuel lean condition. The nozzle geometry has an important influence on injection process and combustion development and shows that degree of conicity can be evaluated for each nozzle by the K- Factor.
Faizal Wan Mahmood,
A Review on Numerical and Experimental Results of Hydrogen Addition to Natural Gas in Internal Combustion Engines, International Journal of Sustainable and Green Energy.
Vol. 3, No. 1,
2014, pp. 6-12.
Orhan A, Zafer D. Internal combustion engines fuelled by natural gas-hydrogen mixtures. Int J Hydrogen Energy 29, pp. 1527 – 1539, 2004.
Ristovski Z, Morawska L, Ayoko GA, Johnson G, Gilbert D, Greenaway C. Emissions from a vehicle fitted to operate on either petrol or compressed natural gas. Sci Total Environ 323:179–94, 2004.
Mello P, Pelliza G, Cataluna R, da Silva R. Evaluation of the maximum horsepower of vehicles converted for use with natural gas fuel. Fuel 85:2180–6, 2006.
GM well-to-wheel analysis of energy use and greenhouse gas emissions of advanced fuel/vehicle systems–a European study. Ottobrunn, Germany: GM, LBST. Available from:http://www.lbst.de/gm-wtw; 2002.
Biagio M, Andrea U. Numerical investigation on the effects of natural gas and hydrogen blends on engine combustion. Int J Hydrogen Energy 34 , pp.4626 – 4634, 2009.
Bauer CG, Fosest TW. Effect of hydrogen addition on the performance of methane-fuelled vehicles. Part I: effect on S.I. engine performance. Int J Hydrogen Energy 26:55-70, 2001.
Wang J, Huang Z, Zheng J, Miao H. Effect of partially premixed and hydrogen addition on natural gas direct injection lean combustion. Int J Hydrogen Energy 34:9239-47, 2009.
Hu E, Huang Z, Liu B, Zheng J, Gu X, Huang B. Experimental investigation on performance and emissions of a spark ignition engine fuelled with natural gas- hydrogen blends combined with EGR. Int J Hydrogen Energy 34:528-39, 2009.
Wang J, Huang Z, Miao H, Wang X, Jiang D. Characteristics of direct injection combustion fuelled by natural gas- hydrogen mixtures using a constant volume vessel. Int J Hydrogen Energy 33:1947-56, 2008.
Wang J, Huang Z, Miao H, Wang X, Jiang D. Study of cyclic variations of direct-injection combustion fuelled with natural gas-hydrogen blends using a constant volume vessel. Int J Hydrogen Energy 33:7580-91, 2008.
Wang J, Chen H, Liu B, Huang Z. Study of cycle-by-cycle variations of a spark ignition engine fuelled with natural gas- hydrogen blends. Int J Hydrogen Energy 33:4876-83, 2008.
Zareei J, Yusoff A, Shahrir A, Faizal M. Comparing the Effects of Hydrogen Addition on Performance and Exhaust Emission in a Spark Ignition Fueled with Gasoline and CNG. Applied Mechanics and Materials. 165: 120-124, 2012.
Hoekstra RL, Collier K, Mulligan N, Chew L. Experimental study of a clean burning vehicle fuel. Int J Hydrogen Energy 20:737–45, 1995.
Nagalingam B, Duebel F, Schmillen K. Performance study using natural gas, hydrogen-supplemented natural gas and hydrogen in AVL research engine. Int J Hydrogen Energy8:715–20, 1983.
Dimopoulos P, Bach C, Soltic P, Boulouchos K. Hydrogen and natural gas blends fuelling passenger car engines: combustion, emissions and well-to-wheels assessment. Int J Hydrogen Energy 33(23):7224–36, 2008.
Apostolescu N, Chiriac R. A study of combustion of hydrogen-enriched gasoline in a spark ignition engine. SAE paper no. 960603.
Bade Shrestha SO, Karim GA. A predictive model for gas fuelled spark ignition applications. SAE Paper No. 1999-01-3482.
Ramos JI. Internal combustion engine modelling. New York: Hemisphere Publication Corporation; 1989.
Hamori F. Exploring the limits of hydrogen assisted jet ignition. PhD Thesis, the University of Melbourne; 2006.
GT-POWER. User’s manual Version 6.2. Gamma Technologies; 2006.
Heywood JB. Internal combustion engine fundamentals. International ed. Singapore: McGraw-Hill; 1988.
How HG, Taib IM, Shahrir A, Yusoff A and Azhari Sh. Experimental Investigation of Performance and Emissions of a Sequential Port Injection Compressed Natural Gas Converted Engine. SAE paper 2009-32-0026 / 20097026.
Kampmann S, Dittus B, Mattes P, Kirner M. The influence of hydro grinding at VCO nozzles on the mixture preparation in a DI diesel engine, SAE paper 1996; 960867.
Ganippa LC, Andersson S, Chomiak J. Combustion characteristics of diesel sprays from equivalent nozzles with sharp and rounded inlet geometries. Combust Sci Technol 175:1015–32, 2003.
Park SW, Reitz RD. Modelling the effect of injector nozzle-hole layout on diesel engine fuel consumption and emissions. J Eng Gas Turb Power 30:032805 (3), 2008.
Macián V, Bermúdez V, Payri R, Gimeno J. New technique for determination of internal geometry of diesel nozzles with the use of silicone methodology. Exp Tech 27:39–43, 2003.
Swain MR, Yusuf MJ, Dulger Z, Swain MN. The effects of hydrogen addition on natural gas engine operation. SAE paper 1993; 932775.
Hoekstra RL, Collier K, Mulligan N, Demonstration of hydrogen mixed gas vehicles, 10th World hydrogen Energy Conference, Cocoa Beach, USA, June 20–24, 1994.
Larsen JF, Wallace JS. Comparison of emissions and efficiency of a turbocharged lean-burn natural gas and hythane -fueled engine. J Eng Gas Turbines Power 119:218–26, 1997.
Bauer CG, Forest TW. Effect of hydrogen addition on performance of methane-fueled vehicles. Part I: effect on S.I. engine performance. Int J Hydrogen Energy 26:55–70, 2001.
Yujun W, Xin Zh, Congxin Li, Jianfeng Wu. Experimental and modelling study of performance and emissions of SI engine fueled by natural gas–hydrogen mixtures. Int J hydrogen energy 35, pp.2680-2683, 2010.
Erjiang Hu, Zuohua Huang, Jiajia He, Chun Jin, Jianjun Zheng. Experimental and numerical study on laminar burning characteristics of premixed methane–hydrogen–air flames. Int J Hydrogen Energy 34, 4876–488, 2009.