Experimental Research on the Effect of Aluminum Additive on the Electromagnetic Radiation in Detonation Process
Volume 4, Issue 6, December 2016, Pages: 398-404
Received: Dec. 6, 2016;
Published: Dec. 7, 2016
Views 1446 Downloads 81
Chen Hong, Ministerial key Laboratory of ZNDY, Nanjing University of Science and Technology, Nanjing, China
He Yong, Ministerial key Laboratory of ZNDY, Nanjing University of Science and Technology, Nanjing, China
Pan Xuchao, Ministerial key Laboratory of ZNDY, Nanjing University of Science and Technology, Nanjing, China
Shen Jie, Ministerial key Laboratory of ZNDY, Nanjing University of Science and Technology, Nanjing, China
He Xun, Ministerial key Laboratory of ZNDY, Nanjing University of Science and Technology, Nanjing, China
Follow on us
Explosions of explosives can produce electromagnetic radiation signals. Based on the theory of the explosion of electromagnetic radiation, the effects of metal additives on the electromagnetic radiation produced by explosive detonation should be researched. In this paper, the electromagnetic radiation signal characteristic produced by the passivation RDX of metal additives explosion were studied by experimental. The rod-shaped antenna measurement system was used to measure the electromagnetic radiation signals generated by the different percentages of aluminum-containing passivation RDX and pure passivation RDX. The results show that the intensity of the electromagnetic radiation signal produced by the explosion is obviously increased by mixing aluminum. In the case of the same explosive mass, the signal intensity of the electromagnetic radiation generated by the explosion increases with the aluminum mass percentage is increased. When the content of aluminum is the same，with the increase of the mass of explosives，the intensity of the electromagnetic radiation signal generated by explosion also increases. The main component of the electromagnetic radiation signal frequency generated by explosives is less than 1MHz，the electromagnetic spectrum generated by explosives with the same composition is consistent.
Explosives Addition of Aluminum, Detonation, Electromagnetic Radiation, Measurement, Spectrum Analysis
To cite this article
Experimental Research on the Effect of Aluminum Additive on the Electromagnetic Radiation in Detonation Process, Science Discovery.
Vol. 4, No. 6,
2016, pp. 398-404.
Takakura T. Radio Noise Radiated on the Detonation of Explosive [J]. Publications- Astronomical Society of Japan, 1955, 7.
Andersen W H, Long C L. Electromagnetic Radiation from Detonating Solid Explosives [J]. Journal of Applied Physics, 1965, 36 (4): 1494-1495.
Cherepenin V A，Cherepenin V A, Shumilin V P. About Mechanism of Wideband Microwave Radiation at Explosion of Condensed High Explosives [M]. Ultra-Wideband Short-Pulse Electromagnetics Springer US, 2002:33–39。
Van Lint V A J. Electromagnetic Emission from Chemical Explosions [J]. Nuclear Science IEEE Transactions on, 1982, 29(6):1843-1849.
Mende F. Electrodynamics and thermodynamics of nuclear explosions and TNT [M]. LAP LAMBERT Academic Publishing, 2014.
Sergeev I Y. Theoretical model of the electromagnetic disturbances caused by explosions in the ionosphere [C]// Electromagnetics in Advanced Applications, 2009. ICEAA. International Conference on. IEEE, 2009:93-96.
Kuhl A L, White D A, Kirkendall B A. Electromagnetic Waves from TNT Explosions [J]. Journal of Electromagnetic Analysis & Applications, 2014, 6 (10): 280-295.
Ma Z, Xie S, Cao J. Application of Wavelet Transform to Process Electromagnetic Pulses from Explosion of Flexible Linear Shaped Charge [C]// International Conference on Computer and Electrical Engineering. 2012.
Kuhl A L, Bell J B, Beckner V E, et al. Spherical combustion clouds in explosions [J]. Shock Waves, 2013, 23 (3): 233-249.
Kuhl A L, Balakrishman K, Bell J B. Ionization Effects in SDF Combustion Clouds [J]. 2012.