American Journal of Civil Engineering
Volume 3, Issue 2-2, March 2015, Pages: 44-52
Received: Jan. 30, 2015;
Accepted: Feb. 1, 2015;
Published: May 9, 2015
Views 5236 Downloads 153
Hasan Dehghanzadeh Najm Abad, Department of Civil Engineering, Azad University, Kerman, Iran
Eisa Salajegheh, Department of Civil Engineering, Bahonar University, Kerman, Iran
Amir Ahmad Hedayat, Department of Civil Engineering, Azad University, Kerman, Iran
The material, form and geometric shape of egghavebeen designed in a way that nobody could ever break an egg squeezing it lengthwise. This research is based on the pattern of human palm. Two soft and concave seating bases are built in order to hold the two ends of the chicken egg. Differentchicken eggs with various geometric shapes were examined by Zwick compression strength test while they were raw, baked and empty. The maximum failing force (breaking of the egg) was 988 Newton.Static linear and nonlinear analysis and modeling of material and geometry is done by Ansys software or with Shell181 element. Early results show that chicken egg content has no effect on its load-application capacity and the reason of breaking are exceeded orbital tensile stresses. With the same thickness, eggs with length to width ratio of 1.4 have the highest load-application capacity and eggs with length to width ratio of 1.7 have the lowest load-application capacity.
Hasan Dehghanzadeh Najm Abad,
Amir Ahmad Hedayat,
A Computer Simulated Model for Load-Application Capacity Check of Chicken Egg, American Journal of Civil Engineering. Special Issue: Research and Practices of Civil Engineering in Developing Countries.
Vol. 3, No. 2-2,
2015, pp. 44-52.
M. Farkhooii, T. Sigaroodi and F. Niknafs,” a complete guide to poultry,” Iran institute of aviculture,1999.http://www.mardoman.net/?id=596&pt=full&sn=articles
C. Perianu a, B. De Ketelaere a, B. Pluymers b, W. Desmet b, J. De Baerdemaeker a, E. Decuypere aa Division MeBioS, KU Leuven, Dept Biosystems, KasteelparkArenberg 30, B-3001 Heverlee, Belgium Department of Mechanical Engineering, Division PMA, KU Leuven, Celestijnenlaan 300B, B-3001 Heverlee, Belgium. biosystems engineering 106 (2010) 79e85. journal homepage: www.elsevier.com/locate/issn/15375110
P. Coucke, G. Jacobs and ets, “comparative analysis of the Static and Dynamic Mechanical Eggshell Behaviour of a Chicken Egg”, In: Proceeding of international Conference on Noise and Vibration Engineering, Long Beach, CA, USA, (1998).
Ashley Lloyd, Tara Vaziri, Sam Yang, “A composite of crystal inelayers and membrane proteins: A mechanical, structural, and compositional investigation of eggshells”, April 18, 2011.
Ahmed, A. M. H., Rodriguez-Navarro, A. B., Vidal, M. L., Gautron, J., Garcia-Ruiz, J. M., &Nys, Y. “Changes in eggshell mechanical properties, crystallographic texture and in matrix proteins induced by moult in hens”, British Poultry Science,(2005),pp 46, 268–279.
S. Nedomova, J. Trnka, P. Dvorakova, “Hen`s eggshell strength under impact loadind”, Mendel university agriculture and foresty, Department of food technology, (2009) 350-357
De Ketelaere, B. Govaerts, T. Couke, P.Dewil, E. Visseher, T. Decuypere, “Measuring the eggshell strength of 6 different strains of laying hens: Techniques and comparison”, British Poultry Science, (2002). 43, 238–244.
Voisey, P. W., & Hunt, J. R.. “Effect of compression speed on the behaviour of eggshells”. Journal of Agricultural Engineering Research,(1969), 14, 40–46.
Buchar, J. Simeonovova, “On the identification of the eggshell elastic properties under quasistatic compression”, In: Proceeding of 19th CAD- FEM users meetig, Berlin, Germany, (2001).
Jacob, J. P. Milles, R. D.& Mather, F. B..”Egg quality”, University of Florida extension, Institute of food and agricultural science,(2000), p. 11.
Narushin, V.G., van Kepmen, T. A., Wineland, M. T., & Christensen, “ Comparing infrared spectroscopy and egg size measurements for predicting eggshell quality”, Biosystem Engineering, (2004).
Ebubekir Altuntas, Ahmet Sekerog, ”Effect of egg shape index on mechanical properties of chicken eggs”, CANADIAN Received 28 May 2007; received in revised form 22 August 2007; accepted 30 August 2007 Available online 24 October 2007.
Anderson, K. E., Tharrington, J. B., Curtis, P. A., & Jones, F. T., “Shell characteristics of eggs from historic strains of single comb white leghorn chickens and relationship of egg shape to shell strength. International”, Journal of Poultry Science, (2004),3, 17–19.
Zlatica, P., Vitorovic, D., Lukic, M., & Spasojevic, I. “Improving egg shell quality by replacement of pulverised limestone by granular limestone in the hen diet”,ActaVeterinaria (Beograd),(2003), 53, 35–40.
Polat, R., Tarhan, S., C¸ etin, M., & Atay, U.,“Mechanical behavior under compression loading and some physical parameters of Japanese quail (Coturnixcoturnix japonica) eggs”, Czech Journal of Animal Science,(2007),52, 50–56.
Tung, M. A., Staley, L. M., Richards, J. F., “Estimation Of Young`s Modulus And Failurs Stresses In The Hen`s Egg Shell”, Canadian Agriculcture Engineering, Vol. 11, No. 1, MAY 1969.
Reissner, E., “Stresses and Small Displacements of Shallow Spherical Shells”, II. J. Math, 1947.
M.M. Bain, “Eggshell strength: a mechanical/ultrastrucutral evaluation” Ph. D. Thesis, University of Glasgow, Scotland( 1992).