Performance of Superconducting Synchronous Generator for Three-Phase Short-Circuit at Its Terminals
Journal of Electrical and Electronic Engineering
Volume 4, Issue 3, June 2016, Pages: 44-50
Received: Mar. 24, 2016;
Accepted: Apr. 8, 2016;
Published: May 7, 2016
Views 3835 Downloads 152
H. Lale Zeynelgil, Department of Electrcal Eng., Electric & Electronics Faculty, Istanbul Technical University, Maslak Istanbul, Turkey
Follow on us
In this paper, three-phase short-circuit at the terminals of a superconducting synchronous generator is simulated by using MATLAB. In this simulation, a single screened superconducting generator directly connected to power system is considered and two operating cases are investigated: the first case is that the fault is permanent and the second case is that the fault is cleaned by a protection system. To show the effects of this short-circuit and the performance of the superconducting synchronous generator for both cases, the deviations of armature momentary currents, angular speed and field current are plotted. In order to compare the obtained results, the present simulations for the both cases mentioned above are repeated for a conventional synchronous generator having the same rating as considered superconducting counterpart, which is directly connected to power system, and the deviations of the same variables as considered for the superconducting synchronous generator are also given in the paper.
Superconducting Synchronous Generator, Screen, Conventional Synchronous Generator, Three-Phase Short-Circuit
To cite this article
H. Lale Zeynelgil,
Performance of Superconducting Synchronous Generator for Three-Phase Short-Circuit at Its Terminals, Journal of Electrical and Electronic Engineering.
Vol. 4, No. 3,
2016, pp. 44-50.
Copyright © 2016 Authors retain the copyright of this article.
This article is an open access article distributed under the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0/
) which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Grant PM (1997) Superconductivity and Electric Power: Promises, Promises ... Past, Present and Future, IEEE Trans. on Applied Superconductivity, 7(2): 112-113
Umans SD (2009) Transient performance of a High-Temperature-Superconducting Generator, IEEE Electric Machines and Drives Conference, 451-457
Bozdag HO (2011) Simulation of Three-phase Short-circuit at the Terminals of Superconducting Synchronous Generator, M.Sc Thesis, Istanbul Technical University, Institute of Science and Technology
Liu X, Liu D, Huang Y (2008) Simulation of Three-phase Short-circuit at the Terminals of Synchronous Machine, ICEM, 115-117
Shenkman, Arieh L. (2009) Transient analysis of Electric Power Circuits Handbook”, Springer
Goddard, K. F., Kukasik, B., Sykulski, J. K. (2009) Alternative designs of High-Temperature Superconducting Synchronous Generator, IEEE Applied Superconductivity, .19(6): 3805-3811
Kalsi, Swarn S. (2002) Development status of Superconducting rotating machines” IEEE Pes Meeting
Furuyama, M., Kirtley, J. L., 1975, “Transient Stability of Superconducting Alternators”, IEEE PAS-94, 320-328
Kirtley JL (1993) Large System Interaction of Superconducting Generators, IEEE Proc. on Power Systems, 81(3): 449-461
Kirtley JL (1981) Armature Motion Damping of High Temperature Superconducting Generators, IEEE Tras.. on PAS, 100(6): 2870-2879