International Journal of Mechanical Engineering and Applications

Special Issue

Electrofusion Joint Design Within Better Efficiency

  • Submission Deadline: 30 March 2020
  • Status: Submission Closed
  • Lead Guest Editor: Aref Rajabi
About This Special Issue
Non-metallic pipes and fittings are very important in industrial piping, so much research is required in this field. One of the usual types of these joints is electrofusion joint. In different aspects , Investigation of these joints is affected on the quality of welding, time of welding and pipelines cost. Our special issue topics related to electrofusion joint are as follows:
  1. Wires effect: Number of wires; location, size and properties of wires; ratio of wire thermal conductivity to polyethylene(PE) thermal conductivity
  2. The volume, mass and geometrical characteristics of joint on welding quality
  3. PE melting and freezing process simulation
  4. Heating, cooling and temperature distribution in welding process simulation
  5. Effects of joint expansion, contraction and temperature distribution simulation
  6. Effects of temperature and earth different climate conditions in joint welding
  7. Effects of wire's electrical and mechanical properties changes in melting and freezing process
  8. Various methods of PE joints production and reducing fixed cost and time
  9. The effect of changing the applied voltage and amperage in the joints
  10. Investigating the effect of various non-dimensional numbers (such as Nusselt, Reynolds, Stephen) on the joints thermal behavior
  11. Simulation and investigation different types of joints such as: Coupler, Transducer, Saddle, Tee, Knee , …
  12. Two and three-dimensional simulation and investigation of above mentioned cases
All experimental, laboratory and numerical articles on this issue and articles submitted by electrofusion joint manufacturers are acceptable.
Aims and Scope:
  1. Polyethylene, Electrofusion Joints
  2. Welding, Temperature Distribution
  3. Melting And Freezing
  4. Joints Thermal Behavior, Production Various Methods
  5. Reducing fixed cost
  6. Joint expansion and contraction
Lead Guest Editor
  • Aref Rajabi

    Department of Inspection, Mazandaran Gas Company, Sari, Iran

Guest Editors
  • Javad Alinejad

    Department of Mechanical Engineering, Azad University, Sari, Iran

  • Keivan Fallah

    Department of Mechanical Engineering, Azad University, Sari, Iran

  • Davood Domiri Ganji

    Department of Mechanical Engineering, Babol Nooshirvani University of Technology, Babol, Iran

  • Reza Najafi Esfandooni

    Department of Hse, Mazandaran Gas Company, Sari, Iran

  • Hamzeh Ahmadi

    Department of ICT, Mazandaran Gas Company, Sari, Iran

  • Peyman Eskandarpour

    Department of Research and Development, Mazandaran Gas Company, Sari, Iran